Wardrobe with MDF panels, by Michel

Create this project yourself with sheet material cut to size by OPMAATZAGEN.nl!

Michel designed this entirely themselves: from cutlist to finish. Get inspired by the materials used below — and then think about how you would tackle it. We make sure the wood is accurate to the millimetre; the rest is up to you.

Description

A wardrobe made in the attic under the sloping space of the roof and using MDF cupboard doors, which hang in a rail system, were created.

Wardrobe under a sloping roof

First of all, a rail system was created on a pair of slats. A rail for the two front MDF panels, behind which a second rail for the rear MDF panel. Then made shelves on the sides and a scaffolding tube in the middle that serves for the hanging area. Made a light point with a switch in the middle of the inside. Then ordered three MDF panels Lakdrager 10mm measuring 168.0 x 153.0 cm that serve as cabinet doors. The rail system allows the plates to serve as a cupboard door.

Large wardrobe made of MDF

495.0 cm by 155.0 cm

Tip! Also check out our handy DIY tips!

Want to build this project yourself?

Not included: Complete kit incl. fittings and instructions
Not included: Design via 3D configurator
Included: Fully made to your own measurements
Included: Edge finish of your choice
Included: Round or curved shapes also possible
Included: Each part available in a different wood type

Not all products from this project are still available. Create the cutlist yourself: every part cut to size, in the wood type and edge finish you want.

Create my own cutlist